Do you want to add 6 more emitters to your existing Hot Link Pro? Or add 6 emitters to Hot Link XL? 6 more emitters can be added to Hot Link Pro with the Emitter Expansion Kit X6. This Kit requires the Emitter Extension Kit to Splice into the Ribbon cable where the additional 6 Emitter Kit X6 can be plugged in.

Or see our new Hot Link XL. With Hot Link XL, no emitter extension kit or splicing is required. The Emitter Expansion Kit X6 can just be plugged in to the Hot Link XL model to add 6 more emitters per kit up to 24 emitters. The additional Emitters can be located at either end of the extension adapter kit. The Hot Link XL could then have 6 emitters close to it with six remotely located, or 12 far away in a remote closet or all 12 near. Hot Link XL Emitters can be extended over 200 feet via Cat-5 cable with RJ45 connectors or 4 wire phone line with RJ11 plugs using the four center conductors.

The Emitter Extension Kit splices into the 6-emitter ribbon cable to extend all 6 emitters with just two wires or category 5 cable with RJ45 Connectors. Once the extension kit is installed for Hot Link Pro, simply plug in the Emitter Expansion Kit X6 into the available RJ45 Jacks on one of the adapter boxes. The additional 6 emitters can be added to either end of the extension kit. This allows 6 emitters at each end of a long extension making essentially 2 zones, or all 12 emitters can be located near to that Main Box and Eye or over 100 feet away.

Note:This Kit requires the Emitter Extension Kit that extends the emitters of the Hot Link Pro.

Instructions, simplified:

1. Install the Emitter Expansion Kit Per instructions.
2. Insert the RJ45 "Y" adapter into one of the ends of the Extension Kit.
3. Insert the short RJ45 cable into the RJ45 "Y" adapter.
4. Insert the other end of the short cable into the Additional Emitter Adapter Box.